Masters Sealer Plus wet-look

Masters Sealer Plus "wet-look", acrylic resin in solvent based

This solvent-based sealer is made from premium, super-tough, non-yellowing acrylics. It creates a high-gloss protection for indoor and outdoor decorative concrete.

• Inside use : It could be applied directly for protect micro topping concrete, self leveling overlay or water based stains. Caution to the odor, it smells a strong solvent odor.
• Outside use : It could be applied on stamped concrete or stencil concrete as a second coat (after a first coat of Masters Ouside Sealer) after 28 days drying.

Advice : For realisations where a special protection is needed (showers, bathrooms, countertops...) it's better to use a bi-component varnish such as Masters PU Ecodur Sealer, Masters Varnish Pro PU or Masters Varnish Pro Epoxy.

This product is based on solvents: PROFESSIONAL USE ONLY

Application

1. Preparing surfaces

The surface must be clean, dry and free of dust and other substances such as paint, oil, grease, fluorescence, glue, or old sealers. If you have any doubts about the cleanliness of the substrate, it is preferable to perform a light sanding with 120 grit.

2. Application

First, protect yourself with gloves, goggles and appropriate mask for solvents.

Masters Sealer Plus "wet-look" must be applied with roller, a brush or a sprayer in two coats. Depending on the weather conditions, each layer should be applied at 12 hours interval. Let it dry during 48 hours before re-use the area.